← Back to shop
Traffic HD

Traffic HD

$260.00

Bona Traffic HD — 2-Component Waterborne Timber Floor Finish

Bona Traffic HD is a 2-component water-based polyurethane topcoat engineered for high traffic intensity — the benchmark commercial floor finish for timber floors in areas where strength, fast return-to-service, and long-term appearance matter. Strong scratch, scuff, and chemical resistance with very low odour and low VOC emissions. Available in Extra Matt, Silk Matt, RAW, and Anti-Slip.

Key Benefits

Technical Snapshot

Recommended System — Bare Timber

Bona requires a primer coat before applying Traffic HD on bare timber. Primer choice depends on timber species and appearance goals:

Standard system: 1 coat primer + 2 coats Traffic HD. Inter-coat abrasion required between coats — see the Bona Traffic HD Technical Data Sheet for full application conditions.

RAW Variant — Extra Notes

Traffic HD RAW is designed to retain the look and feel of raw, finely sanded timber while providing a sealed, durable surface. It carries a P3 slip resistance classification (AS/NZS 4586), making it suitable for stairs and commercial areas where slip compliance is required. Bona Prime Classic UX is the recommended primer for the RAW system. Note: Traffic HD RAW cannot be maintained with Bona Freshen Up or shine-based polishes — use Bona Cleaner for ongoing maintenance.

Not Sure If Traffic HD Is Right?

For heavy residential or light-to-moderate commercial floors where a full commercial spec isn't required, Bona Wave 2K is a genuine 2K alternative at the right level of specification. For a raw timber oil look rather than a waterborne system, consider Bona Hard Wax Oil.

Downloads

Common Questions

Does Traffic HD need a primer on bare timber?
Yes — Bona specifies a compatible primer coat before Traffic HD on bare timber. Choose between Prime Classic UX (standard species), Prime Intense (high tannin species), or Prime White (whitened appearance).

Can I use Traffic HD on pre-finished floors?
Yes, Traffic HD is listed as suitable for pre-finished floors. Correct adhesion prep and the Bona overcoating specification apply.

How long before the floor can be used?
Light traffic at 6 hours, full use at 12–24 hours under normal conditions (20°C, 50% RH).

Do I need to sand between coats?
Inter-coat sanding requirements depend on the time between coats and site conditions. Refer to the Technical Data Sheet for your specific system and timing.

Complete the System

Cart 0