← Back

Bona Toner Natural

Semi-transparent natural pigment additive. Keep the timber reading raw and hold back the yellow.

What it is

Bona Toner Natural is a water-soluble pigment additive in a pre-measured 100 ml bottle, part of Bona's Additive+ range. It's semi-transparent -- you mix it into a Bona waterborne primer or lacquer to keep the floor looking like raw, freshly-sanded timber and to hold back the amber/yellow pull a clear coat can add. Used with Bona Classic UX primer it replicates the look of the Bona Natural primer.

Why installers use it

Coverage & specs

How to apply

Sand to bare timber and dust off. Shake the bottle hard for 60 seconds, add one bottle per 5 L and stir. Best in the primer rather than the lacquer. Standard schedule is two primer coats with the toner, then one to two clear lacquer coats -- finish matt for the truest raw look. If you need to abrade to knock back grain raise, do it after the first lacquer coat. Always test on a sample board in the actual species; Toner Natural is a tonal tool, not a dark-to-light change.

Safety (from the Bona SDS)

Not classified as hazardous under CLP/GHS -- no signal word or pictograms. Contains trace isothiazolinone preservatives and may produce an allergic reaction on sensitive skin. Wear gloves and eye protection, ventilate, and keep out of drains and watercourses.

First aid: eyes - rinse 10+ minutes; skin - soap and water (not solvents); do not induce vomiting if swallowed. Technical detail: Bona Toner TDS (PDF). Colour-specific SDS available from Bona on request.

Chasing the raw look?

Ring with the species and the square meters and we'll line up the primer, the matt lacquer and the number of tinted coats to keep it looking untreated.

Call 1300 950 551

The rest of the range

Toner White, Toner Amber, Toner Black. See the method in our guide: tinting a floor with Bona Toner →

See the full range · Related FAQs →